How to disassemble the scientific energy storage fan

How do you replace a fan motor?

Flip your fan around and find the screws in the back. With your pin and front motor mostly exposed, turn your fan over to inspect the opposite side of the motor case. On most fans, there will be a plastic vent that allows heat and air to escape from the motor. There will be screws on the back holding this case in place.

How do you fix a fan that won't turn on?

If there’s some plastic cover or case on front of the motor, unscrew the plate blocking the body of the motor. Flip your fan around and find the screws in the back. With your pin and front motor mostly exposed, turn your fan over to inspect the opposite side of the motor case.

How do you lubricate a fan vent?

Spray the plastic vent on the back with compressed air. Take the vent cover that you unscrewed before you lubricated your fan and hold it away from your motor. Spray both sides of the cover with compressed air to get the dust out of the hard-to-reach spaces between the vent’s bars. Wipe the cover down with a dry cloth.

How do you remove a fan blade?

Feel around the sides of the blade guards for clips that are holding the 2 parts together. If there are clips, unhook them and remove the front half. If you don’t see any hooks keeping the blade assembly together, try turning the circular center of the fan counterclockwise. If it loosens, unscrew it and set the front of the blade case down.

Why do fan blades stop spinning?

A dried out or sticky pin is one of the most common reasons for blades to stop spinning. If they spin easily and there’s no resistance, try turning your fan on and see if the pin spins. If it doesn’t, the problem isn’t the pin and there is probably a short in the motor. In this case, it’ll probably be easier to get a new fan.

Can you use water to clean a fan?

Warning: Do not use water to clean the area around your motor. If water gets on the motor, it could cause an electrical short or destroy your fan. Spray the plastic vent on the back with compressed air. Take the vent cover that you unscrewed before you lubricated your fan and hold it away from your motor.